
VEVOR 1.5 HP Single-Speed Pool Pump
A 115V pump rated up to 5,280 GPH for straightforward replacements.
Compare common Hayward platforms, motors and replacement considerations without guessing at fit.
See matched products ↓As an Amazon Associate, we may earn from qualifying purchases.
The correct pump must move the required water through the actual plumbing system without exceeding the filter’s rated flow. Start with pool volume and turnover, then confirm total dynamic head, voltage, pipe size, controller requirements and service clearances.
Horsepower is useful only after those constraints are understood. Two pumps with the same nominal horsepower can produce different flow at the same head, use different connections and behave differently at low speed. Always compare the manufacturer curve and installation manual for the exact model.

A 115V pump rated up to 5,280 GPH for straightforward replacements.

Dual-voltage, self-priming pump rated up to 6,900 GPH.

A 56Y-frame replacement motor for compatible pump housings.

Square-flange 56Y replacement motor for compatible Pentair-style pumps.

A dual-voltage square-flange replacement motor for specifically compatible pump housings.

A replacement motor listed for compatible Century, Regal Beloit and A.O. Smith applications.

A single-speed replacement listed for compatible Pentair WhisperFlo applications.

A round-flange, dual-voltage replacement motor requiring an exact 56J fit check.

A 230V square-flange replacement motor for compatible pool and spa pump housings.

A round-flange Century motor for applications matching the complete UST1102 specification.

A familiar round-flange motor requiring verification of voltage, service factor and pump compatibility.

A rebuild kit listed for specified Pentair pump generations built from February 2008 onward.

A maintenance kit listed for specific Hayward Super Pump SP1600 and SP2600 families.

A seal kit listed for compatible WhisperFlo and IntelliFlo pump repairs.

A rebuild assortment listed for compatible Pentair SuperFlo and SuperMax pumps.
Divide pool gallons by the desired turnover hours, then by 60. Treat that number as a starting point, not the final answer. Suction length, fittings, elevation, filter pressure, heater restriction and water features all change the operating point.
A pump that can deliver more flow than the filter or plumbing can accept may create noise, high pressure and poor efficiency. The system’s safe limit is set by its most restrictive component.
Purchase price is only one part of ownership. A controllable pump operating near its efficient range can cost less over time than an inexpensive pump that runs at full speed for every task.